Difference between revisions of "Porsche 928 LH Replacement Prototype"
From Francois Louw
(→PCB Creation and populating) |
|||
Line 76: | Line 76: | ||
The PCB that I must make is a two layer pcb with 0.006" gaps between tracks and 0.012" vias. That is small, and I cannot do it at home. So I sent the info to specialists and received my PCB (5 of them). | The PCB that I must make is a two layer pcb with 0.006" gaps between tracks and 0.012" vias. That is small, and I cannot do it at home. So I sent the info to specialists and received my PCB (5 of them). | ||
− | All the components were ordered from Digi-Key. 34 Different components | + | All the components were ordered from Digi-Key. 34 Different components (840 components in total for 5 boards) |
After I got the PCB and components it was time to play around with solder paste and put all the components on. I baked the PCB, and then soldered on the through hole components. | After I got the PCB and components it was time to play around with solder paste and put all the components on. I baked the PCB, and then soldered on the through hole components. |